best airless paint sprayer under 100
I am sure you will be able to choose the right product from this list of best airless paint sprayer under 100
Graco Ultramax, and Ultra handheld airless sprayers We’ll cover the differences between the two models. When you may consider one or the other. Why the units are useful in certain use applications, and some of the common questions we get. So what we have here is the Graco UltraMax airless, handheld airless, and the main differnece between this and the Ultra. This unit is capable of spraying any solvent, or water-based material, as far as from a safety standpoint. There are limitations to the unit, as far as pressure and tip size. The maximum tip size the unit will support is a 16,000ths tip, which means it can spray materiel anywhere from a thin to medium viscosity, but beyond that it will start to have a little trouble. It’s also limited to 2000 psi’s. So if your material’s very thick, you’d either have to thin it pretty significantly, or use a material that isn’t as thick so you can spray it. Usually airless sprayers are 3000 psi, or higher. So you have less pressure to break up a material. It does come with a collapsible cup, which enables you to spray upside down or side to side. There’s a prime valve on the side, for spraying prime, and then this valve is for you to get started. You open it ans then you squeeze the bag, so that the material is pulled up into the unit. The battery lasts up to a gallon, or up to an hour of spray. Depending on the thickness of the material, and use. You may get a little less time than that. Any standard 20 volt DeWalt battery will be used be usable with the unit. Cost differences as you step down from the Ultramax, which can spray solvent or water-based. The Ultra unit can only spray mineral-based mineral spirit-based materials or water-based. Same with the Ultra corded. The difference between them though, is a . With the Ultra corded only unit about , and then you jump up to 499 for the Ultra, and then the UltraMax which is , but if you’re spraying a variety of materials, and want flexibility. The UltraMax would be your go to choice. If you’re only doing occasional projects around the home, with a water-based product. Then you could just consider the Ultra, or the Ultra corded model, or if using a mineral-based mineral spirit-based product only. Now those are relatively rare. There’s not a lot of coatings out there anymore that are only mineral spirit-based. Well we got the unit kind of set up here. The material I’m using’s at the higher end of viscosity. For the unit it’s about unthinned thickness of the latex. Added a little, thinned it down a little bit to get it to go. Well, to use the unit you basically start by opening up the valve, and making sure that all your material has been, all the air has been pushed out of the bag, and then you can close this, and then you can use the prime valve to get the unit primed. (unit running) Using that for a few seconds. Then I can turn it to spray. The collapsible bag makes clean up easy. This just unscrews, and then you can throw away the bags, and the UltraMax comes with a few extra bags, compared to the Ultra. We’ll go ahead and show you how it breaks up material, here. This material is a ProClassic by Sherwin-Williams. It’s a common cabinet finish for some cabinet painters like it. So it’s a mid viscosity. I didn’t need to thin it very much. These use fine finish tips, so they are and tend to be a little more prone to plugging compared to standard airless tips, but they are reversible. (unit runs) I have a four inch pattern (unit runs) you can put it (unit runs) actually get pretty good I get very good break up, and it’s a finer finish, so if you wanted to use this for wood finishing, for touch up work, even an occasional job around the home, or if you want to get a little larger tip you could be doing work that’s fences, and a little bit larger targets as well. (unit runs) and so as you it works really well. It lays down material. If you get about a medium viscosity, or a 16000ths tip. That your materials require. This one is actually set up for 2000 psi spray. That’s what the material calls for so. Mid to thin viscosity materials with smaller tip sizes, up to 16000ths. These units can’t be beat for what they do, as for touch-ups, or smaller jobs around the home. The UltraMax would be the safest, as far as for solvents or water-based, and if you have questions on any of these units, and if one of them might be right for your work, I am sure you will be able to choose a best airless paint sprayer from this list.